Engineering

Good night , I need to make 4-5 3D models for the racing simulator. The size is all. I add a picture, about what I need.

The task is to design and develop a scheme of linear guidelines for the mechanism of cutting gums conveyor bands on toothbags. There is detailed information. It requires understanding of linear SNR modules and integration with Siemens Simatic HMI

I'm looking for a specialist to install on the site (www.inkit.com.ua) an online calculator to calculate the area of the cutting air conducts, i.e. Ventilation channels and accompanying (fason) products. The results of the area calculations must be multiplied by the cost of 1 m2…

It is necessary to arrange the physical network and the available equipment, in this regard it is necessary a server closet (selection, connection), which can be hanged on the wall on the warehouse taking into account the following: 1 .Protection against dust (beton floor,…

A specialist is needed to set up MasterScada. It is necessary to adjust the water consumption calculation (20 calculation devices), with minimum reporting requirements.

Dobrij den, nuzen projekt vodosnabzenija i kanalizacii, dlia doma, v budushcem nuzen budet projekt elektricestva i ventiliacii, zdem predlozenij, S lucshimi pozelanijami iz Litvy